| Layer thickness | 1–4 μm reference for selected stainless steel systems. | 1–4 μm reference for selected stainless steel systems. Account for the interlayer. | Thin topcoat. Set acceptance by surface performance. | Specify the required buildup and the local minimum at measurement points. |
|---|
| Hardness and wear | Review hardness when the surface has a wear requirement. | Agree an instrumented indentation method and verify adhesion independently. | Evaluate the topcoat after abrasion on the specified substrate. | Depends on the deposited metal, undercoat and required service. |
|---|
| Friction and surface behavior | Start with the approved texture, color and gloss sample. | Test friction and wear with the intended counterpart, load and lubrication. | Measure contact angle and cleanability on matched samples. | Inspect corrosion, electrical or decorative performance as specified. |
|---|
| Heat and coverage | Check the substrate’s allowed temperature and shadowing in grooves. | Check tempering history, allowable heat input and coverage on working faces. | Check topcoat compatibility with the approved base finish and cleaning process. | Review current distribution and solution access in holes and recesses. |
|---|
| Typical use | Watch cases, clasps and decorative hardware. | Sliding pins, guides and loaded contact faces. | Touch surfaces on cases, controls and trim. | Corrosion protection, conductive contacts or dimensional buildup as specified. |
|---|